Arm-electronics SDKBD2&3 Bedienungsanleitung PDF herunterladen (Seite 6)

2. Rear Panel (Figure 2)

(Figure 2)

A. Power input connector: input DC12V power.

B. ID-Code switch: Used to set the protocol in use and the baud rate of communications.

C. Communication connector RS485: The controller is connected to adapter box by specific cable.

IV. Setting of the Keyboard

a) The protocol in use and the baud rate of communication of the keyboard are set by the

ID-CODE in Figure 2. DIP1-DIP4 are used to select type of the communication protocol as

per following table：

DIP status Normal Baud Rate

Protocols

DIP-1 DIP-2 DIP-3 DIP-4 DIP-5 DIP-6

COP-2 ON OFF OFF OFF OFF ON

Santachi OFF ON OFF OFF OFF ON

PELCO-D ON ON OFF OFF OFF OFF

PELCO-P/4800 ON OFF

PELCO-P/9600

OFF OFF ON OFF

OFF ON

PANASONIC ON OFF ON OFF OFF ON

Reserved OFF ON ON OFF OFF ON

HUNDA600 ON ON ON OFF OFF ON

LILIN OFF OFF OFF ON OFF ON

Reserved ON OFF OFF ON ON OFF

Reserved OFF ON OFF ON OFF ON

KALATEL ON ON OFF ON ON OFF

Reserved OFF OFF ON ON OFF ON

Reserved ON OFF ON ON OFF ON

COP-1 OFF ON ON ON OFF ON

Ultrak ON ON ON ON OFF ON

COP-03 OFF ON ON OFF OFF ON

COP-04 ON OFF ON ON OFF ON

b) DIP5 and DIP6 are used to select the baud rate, shown as following table (DIP7 and DIP8

are not used)：

Status of ID-CODE

Baud

Rate

DIP1 DIP2 DIP3 DIP4 DIP5 DIP6 DIP7 DIP8

2400bps OFF OFF

4800bps ON OFF

9600bps OFF ON

19200bps ON ON

c) Some of the ID-CODE of the protocols are set as follows:

1 2 3 4 5 6 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare

Arm-electronics SDKBD2&3 Bedienungsanleitung Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kamerarekorder Arm-electronics SDKBD2&3